Removal and Replacement Procedures
HP ProLiant BL20p Generation 3 Server Blade Maintenance and Service Guide
2-23
3.
Disengage the thumbscrews (1) and remove the power converter modules (2).
4.
Remove the power converter module retainers from the power converter module pair (2)
and store for use on the new power converter module.
NOTE:
The server requires two power converter modules installed one on top of the other. The
power converter modules may separate during removal or installation, be sure to align the modules
and press together before installing on the system board.
Figure 2-21: Removing the power converter module
To replace the component, reverse the removal procedure.
NOTE:
When replacing a power converter module, be sure to remove the caps from the old power
converter module and install the caps on the new power converter module.
DC Filter Module
To remove the DC filter module:
1.
Power down the server blade and remove it from the server blade enclosure. Refer to the
“Server Blade Preparation” section in this chapter.
2.
Remove the access panel. Refer to “Access Panel” in this chapter.
