Removal and Replacement Procedures
HP ProLiant BL20p Generation 3 Server Blade Maintenance and Service Guide
2-7
Access Panel
To remove the access panel:
1.
Power down the server blade and remove it from the server blade enclosure. Refer to the
“Server Blade Preparation” section in this chapter.
2.
Loosen the thumbscrew (1).
3.
Press down on the thumb indentations, slide the access panel toward the rear of the unit
about 1.25 cm (0.5 in), and lift to remove the panel (2).
Figure 2-3: Removing the server blade access panel
To replace the component, reverse the removal procedure.
