Use
to determine which nodes and storage devices should be presented during each step.
Table 16 Power sequencing for cluster installation
Step
Node 1
Additional
Nodes
Storage
Comments
Setting Up
Networks
On
On
Not
Presented
Verify that all storage devices on the
shared bus are not presented; Power
on all nodes.
Setting up
Shared Disks
On
Off
Presented
Shut down all nodes. Present the shared
storage, then power on the first node.
Verifying Disk
Configuration
Off
On
Presented
Shut down first node, power on next
node. Repeat this process for all cluster
nodes.
Configuring the
First Node
On
Off
Presented
Shut down all nodes; power on the first
node.
Configuring
additional
Nodes
On
On
Presented
Power on the next node after the
first node is successfully configured.
Complete this process for all cluster
nodes.
Post-installation
On
On
Presented
At this point all cluster nodes should be
on.
To configure the Cluster service on the storage server, an account must have administrative permissions on
each node. All nodes must be member servers within the same domain. It is not acceptable to have a
mix of domain controllers and member servers in a cluster.
Setting up networks
Each cluster node requires at least two network adapters—one to connect to a public network, and one to
connect to a private network consisting of cluster nodes only.
The private network adapter establishes node-to-node communication, cluster status signals, and cluster
management. Each node's public network adapter connects the cluster to the public network where
clients reside.
Verify that all network connections are correct, with private network adapters connected to other private
network adapters only, and public network adapters connected to the public network.
Configuring the private network adapter
The following procedures are Best Practices provided by Microsoft and should be configured on the
private network adapter.
•
On the
General
tab of the private network adapter, ensure that only TCP/IP is selected.
•
Ensure that the
Register this connection's address in DNS
is not selected in the DNS tab
under advanced settings for the private network adapter.
•
Ensure that the
Link Speed and Duplex
is set to 100Mps/Full Duplex under the
Advanced
tab for the Ethernet card used for the private network adapter.
•
In all cases, set static IP addresses for the private network connector.
Configuring the public network adapter
While the public network adapter's IP address can be automatically obtained if a DHCP server is
available, this is not recommended for cluster nodes. HP strongly recommends setting static IP addresses
for all network adapters in the cluster, both private and public. If IP addresses are obtained via DHCP,
HP ProLiant Storage Server administration guide
181
Содержание ProLiant 300 Series
