7
Figure 6
Attaching the mount panel to the wall
3.
Run the required network cable through the top, bottom, or side of the wall mount panel allowing
sufficient length for the cable to reach the not-yet installed HP NJ5000-5G-PoE+.
4.
Tighten the screws or tap the wall anchors flush with the wall to secure the mount panel to the wall.
5.
Place the mounting bracket, with the UP arrow pointing up, on the wall mount panel. Use four
mounting screws to secure the bracket to the panel.
Figure 7
Attaching the mounting bracket to the wall mount panel
6.
Connect the network cable from the panel to the RJ-45 uplink port on the back of the HP
NJ5000-5G-PoE+.
HP Unified
Wired-
WLAN
Walljack
Table/Flush
Wall Mount
Kit
(JL022A)
