Chapter 4
Diagnostics
37
Code
Description
Problem/Solution
0510
Hard Disk boot Error
Error codes #0510,
#0511, #0512, and
#0513 apply to IDE0,
IDE 1, IDE 2, and IDE
3 respectively as
described in the
Setup Utility
).
(This does not apply
to LP 2000r)
POST has detected the specified hard disk drive reported an error
during its self-test.
To correct this:
1. Check the hard disk drive configuration with the
Setup
Utility
.
2. If necessary, edit the user hard disk parameters to set lower
values.
3. If the problem persists, your drive may need to be replaced.
Contact your service representative.
0520
Hard Drive not
responding
(Error codes #0520,
#0521, #0522, and
#0523 apply to
HDD0, HDD1, HDD2,
and HDD3
respectively as
described in the
Setup Utility
).
(This does not apply
to LP 2000r)
POST has detected the specified hard disk drive is not responding,
but is configured in the
Setup Utility
.
To correct this:
1. If the specified hard disk has just been removed, press
[F4]
to automatically validate the change.
2. Verify all data cables and power cords are firmly connected.
3. If the cable is damaged, connect the hard disk drive to
another IDE cable, if available.
4. If the problem persists, your hard disk drive may need to be
replaced. Contact your service representative.
0530
Hard Disk drive
connection problem
The IDE cable
(primary channel)
marked IDE cable
<#0530>. The
secondary channel
cable marked IDE2
<#0531>
(This does not apply
to LP 2000r)
POST has detected a hard disk drive on the second <slave> position
on the IDE cable, but no hard disk has been found on the first
<master> position.
To correct this:
1. If only one hard disk is connected on the cable, disconnect
the hard drive and use the other connector to re-connect the
hard drive into the first <master> position.
2. If two disks are connected on the cable, verify all data cables
and power cords are firmly connected for both hard disk
drives.
3. If the error message appears just after a hard disk drive
installation, check for master/slave specific jumper
configurations in the hard disk drive installation manual.
4. If the problem persists, the hard disk drive may need to be
replaced. Contact your service representative.
0540
Hard Disk Controller
resource conflict
(This does not apply
to LP 2000r)
POST has detected an address space or IRQ resource conflict
between the integrated hard disk controller and an accessory board.
To correct this:
1. If the integrated hard disk controller is not needed, run the
Setup Utility
to disable it (primary or secondary).
2. If the integrated hard disk controller is needed, the accessory
board's IRQ and address space must be reconfigured to use
other free resources. Refer to the accessory board
installation manual for information.