HP LH6000r - NetServer - 0 MB RAM, Руководство по обслуживанию, Страница: 66 / 114

Chapter 5 Troubleshooting
60
12. If you wish to set the password again, during the power-on system hardware test press the [F2]
function key to start the Setup utility.
13. Set the new password in the Security menu.
14. Press the [F10] function key and answer
Yes
to save the configuration, including the new
password.
15. Exit the Setup utility.
BIOS Recovery
If the BIOS becomes corrupted, it is possible to perform a BIOS recovery to correct the condition. A BIOS
Update diskette must be created from the HP NetServer Navigator CD-ROM to be used in flashing the new
BIOS into the NetServer. To update the BIOS, you enable the Boot Block by setting the Boot Block switch
(switch 7) of the configuration switch on the system board assembly to the ON (enabled) position.
To perform a BIOS recovery:
1. Power down the HP NetServer and gain access to the system board assembly.
2. On the system board, set the Boot Block switch (Switch 7), on the configuration switch, from
OFF to ON.
CPU Speed
CPU Speed
CPU Speed
Clear Config
Clear Password
Not Used
1
2
3
4
5
6
7
8
O
N
Switches 1 and 4 of
dual in-line switch,
S1, shown in the
ON position.
System Board Assembly Configuration Switch
3. Replace the system board assembly.
4. Place the previously created BIOS Update diskette into the floppy drive of the HP NetServer
and power up the HP NetServer.
5. The flash program on the diskette will re-program the BIOS into the HP NetServer.
6. When the flash programming is completed, power down the HP NetServer.