HP LH6000r - NetServer - 0 MB RAM, Руководство по обслуживанию, Страница: 59 / 114

Chapter 4 Diagnostics
53
4. If the problem persists put your memory module in another socket. If the error code changes
and indicates the new location of the memory module, it needs to be replaced. Contact your
service representative.
5. To allow the HP NetServer to start with the remaining available memory, remove the defective
module and change the memory size in the Setup utility.
0800 The cache memory size detected during the power-on self-test is smaller than previously detected. The
cache memory module is either disconnected, defective or has been replaced by a smaller one.
1. If the cache memory module has just been removed or replaced by a smaller one, press [F4] to
automatically validate the change.
2. If the cache memory module has not been removed or changed, ensure it is properly inserted in
its socket.
3. If the problem persists, the cache memory module may need to be replaced. Contact your
service representative.
0801 The cache memory module has reported an error during its self-test.
1. Remove the cache memory module from its socket and clean the edge connector. Refer to your
HP NetServer Installation Guide for handling precautions.
2. Re-install the cache memory module.
3. If the problem persists, your cache memory module may need to be replaced. Contact your
service representative and specify the error code.
0900 The integrated LAN interface has reported an error during its self-test.
1. Check that the LAN interface is properly inserted in its slot.
2. Check that the COAX module is correctly installed (if present).
3. Check that all the cables are firmly connected.
4. If the problem persists, your LAN adapter may need to be replaced. Contact your service
representative.
0901 The integrated LAN interface is not responding.
1. If the integrated LAN interface has just been removed, press [F4] to automatically validate the
change.
2. Check that the LAN interface is properly inserted in its slot.
3. Check that all cables and power cords are firmly connected.
4. If the problem persists, your LAN adapter may need to be replaced. Contact your service
representative.
0B0XYour system is missing the Microcode Update data block for the Pentium III microprocessor.
You must correct this problem in order to avoid possible malfunction or reliability problems.
To correct the problem, update your BIOS by running the flash utility from your HP NetServer Navigator CD-
ROM . To do this, insert the HP NetServer Navigator CD-ROM in the CD-ROM drive and power-cycle your
system. See BIOS Recovery.
If updating your BIOS does not clear this error, contact your service representative.