HP Integrity rx1620, Руководство по эксплуатации

Страница: 61 / 136

Chapter 4
Utilities
Management Processor
61
Step 2. Place a jumper between pins 7 and 8 on J96 located on the system board near the battery.
Figure 4-2 Password Reset Jumper
Step 3. Plug in the AC power cord and wait for the BMC heartbeat LED on the system board to start
blinking green. This should take about 5 seconds from the time you plug in the power cord.
Step 4. Unplug the AC power cord again and remove the jumper.
Step 5. Plug in the power cord and boot the system.
Step 6. The passwords have been cleared. Follow the instructions above to set new system passwords.
Step 7. Store the system in a secure location and keep the system case locked at all times to protect against
unauthorized access.
Management Processor
The management processor is an independent support system for the server. It provides a way for you to
connect to a server and perform administration or monitoring tasks for the server hardware.
The management processor controls power, reset, Transfer of Control (TOC) capabilities, provides console
access, displays and records system events, and can display detailed information about the various internal
subsystems. The management processor also provides a virtual front panel that can be used to monitor
system status and the state of front panel LEDs. All MP functions are available via the LAN, local RS-232
and remote RS-232 ports.
The management processor is available whenever the system is connected to a power source, even if the
server main power switch is in the off position.
Access to the management processor can be restricted by user accounts. User accounts are password
protected and provide a specific level of access to the server and management processor commands.
Multiple users can interact with the management processor. From the MP Main Menu users can select any of
the following options: enter management processor command mode, enter console, view event logs, view
console history, display virtual front panel, enter console session, or connect to another management
J96
Pin 8
Pin 7