12.
If it is necessary to replace the webcam/microphone module or touch control board cable, follow these
steps:
a.
Remove the display panel assembly.
b.
Disconnect the touch control board cables from the touch control board (two locations) (1).
c.
Detach the touch control board cable (2) from the display back cover. (The touch control board cable is
attached to the display back cover with double-sided adhesive.)
Component replacement procedures
45
Содержание ENVY x360 13
