HP e-pc s10, Руководство пользователя

Страница: 24 / 64

My e-pc doesn’t start properly
16
Serial or parallel port test error
Note: such an error may occur when your e-pc starts up and performs a Power-On Self Test (POST)
Have you checked that... How
The port is correctly configured in the e-pc’s
Setup
program
1 Switch the e-pc OFF then ON.
2 When the message P PP Prrrreeeess ss ss ss FFFF2 2 2 2 tttto o o o En En En Entttteeeer r r r S SS Seeeettttuuuupppp appears,
press the
F2
key. Refer to page 38.
3 Check the port is enabled and the correct setting is
selected under IIII////O
O O O D D D Deeeevvvviiiicccce e e e C CC Coooonnnnffffiiiigggguuuurrrraaaattttiiiion on on on.
The device is connected correctly and is
switched on
1
Switch off the e-pc.
2 Plug the cables into the correct connectors on the
back of the e-pc.
3 Switch on the e-pc and the external devices.
The correct device drivers are installed Refer to the documentation for your serial or parallel
device.
There is not a hardware problem Run e-DiagTools. Refer to page 30.
The e-pc has the latest BIOS version Download the latest BIOS and instructions for its
installation from HP’s Web at:
www.hp.com/go/e–pcsupport
IIIIf
f f
f tttthhhhe
e e
e pppprrrroooobbbblllleeeem
m m
m ppppeeeerrrrssssiiiissssttttssss,
, ,
, ccccoooonnnnttttaaaacccct
t t
t yyyyou
ou ou
our
r r
r aaaauuuutttthhhhoooorrrriiiizzzzeeeed
d d
d ssssup
up up
upppppoooort
rt rt
rt pppprrrroooovvvviiiiddddeeeerrrr
You get a “non-system disk” or ”operating system not found” message
Have you checked that ...
How
There’s not a non-bootable floppy disk in an
external floppy drive when you started the
e-pc 1 Remove the floppy disk if there is one in the drive.
2 Restart the e-pc.
The device boot order is correct in the
Setup
program
1 Enter the
Setup
program by pressing
F2
when
prompted during start-up. Refer to page 38.
2 Reload the default
Setup
values by pressing
F9
.
3
Press
F10
to exit
Setup
saving changes.