HP Compaq Presario,Presario 2140, Руководство пользователя

Страница: 136 / 244

Configuring the Director
136 Director Product Manager User Guide
Note: The factory default for LIN alerts is “enabled.”
4. Prevent an unspecified device from being connected to the port when you
click the check box in the Port Binding column.
5. To set the data speed for the port, click in the Speed column for the port, and
choose 1 Gb/sec, 2 Gb/sec, or Negotiate. When you choose Negotiate, it
allows the port and attached device to negotiate the data rate.
Note: Note that your director model and firmware may not allow 2 Gb/sec data
speeds.
6. Click the Bound WWN field, and type the WWN or nickname of the specific
device to be connected to the port.
7. Use the scroll bar on the right side of the Configure Ports dialog box table to
display additional ports that you want to configure.
8. Click Activate to activate the changes and close the dialog box.
9. If you are finished configuring the switch, back up the configuration data. For
more information, refer to “ Backing Up and Restoring Configuration Data ”
on page 157.
Configuring Port Addresses
FICON management style only. Use this procedure to create and activate port
address configurations.
Parameters
■
Addr—This read-only field lists the port’s address. Each port in the switch
has a corresponding port address which equals the physical port number plus
four. Therefore, the address for port 0 is 4 (0+4).
■
Port Name—This user-defined name is assigned to the address. Up to 24
alphanumeric characters are allowed, including spaces, hyphens and
underscores.
■
Blocked—If the box is checked, the port is blocked. Blocked ports
continuously transmit offline sequences (OLS), but cannot communicate to an
attached device. If the box is not checked, the port is unblocked.