52
Using Restore
Disaster Recovery for Windows NT
A minimal install of the Windows NT Workstation will be performed from the
Disaster Recovery Set.
Disaster Recovery screens will display messages instructing you when to insert
each of the four diskettes from your Disaster Recovery Set.
To use Disaster Recovery:
1.
Insert the Windows NT Workstation Setup Boot Disk (diskette #1 of the DR
Set) and restart your computer. You will be guided through a partial NT
installation.
Only the boot drive and the NT installation drive need to be partitioned at
this time. You will be able to partition and format other drives at a later time
through the Disk Administrator in the Disaster Recovery process.
2.
Restart your computer when prompted.
The Recovery Wizard should appear now and guide you through the steps
necessary to recover your system.
Note:
If setup determines that your primary partition is not set up (i.e.
if your C drive is not partitioned or formatted), then you will be
prompted to do so. You should attempt to partition any new
drive(s) to the same settings as were set before the drive failure.
3.
After you have restored all the files from your backup volumes, reboot the
machine to complete your recovery.
Содержание C4405A - Colorado 14GB Tape Drive
