Adding, Replacing, or Removing a Transceiver
C a u t i o n
When adding, removing, or replacing a transceiver from a module,
always remove the module from the Switch 2000 first. Otherwise, you
might interrupt proper switch operation and/or damage the module or
transceiver circuitry.
For proper cooling and for reduction of electromagnetic emissions,
ensure that a slot cover (provided with your Switch 2000) is installed on
any unused port or transceiver slot.
1. Disconnect any network cables attached to the module for which
you will add, replace, or remove a transceiver.
2. Remove the module from the Switch 2000.
a. Loosen the screws in the extractor handles of the module.
b. Simultaneously rotate both extractor handles downward and pull
the module toward you until it releases from the slot and the
Fault and status LEDs for that slot are off.
c. Slide the module out of the slot.
loosen these two screws
Figure 8.
Removing the Module from the Slot
11
Содержание AdvanceStack 100VG
Страница 1: ...HP AdvanceStack Switch 100VG Module Installation Guide ...
Страница 6: ......
Страница 8: ......
Страница 25: ......