Removing or Replacing a Module
Use this section to do either of the following:
Replace one module with another
Remove a module without replacing it
1. Remove any network cables from the ports on the module.
2. Loosen the screws in the extractor handles of the module you want
to remove from the switch.
3. Simultaneously rotate both extractor handles downward and pull the
module toward you until it releases from the slot and the Fault and
status LEDs for that slot are off.
N o t e
During removal (or installation) the module and switch connectors will
momentarily be only partially connected. The fault LED for the slot
flashes rapidly to indicate this state, and normal switch operation is
temporarily suspended until the module connector is completely
separated from the switch connector. The other switch modules will
continue to forward packets normally, though.
4. Slide the module out of the slot.
loosen these two screws
Figure 7.
Removing the Module from the Slot
9
Содержание AdvanceStack 100VG
Страница 1: ...HP AdvanceStack Switch 100VG Module Installation Guide ...
Страница 6: ......
Страница 8: ......
Страница 25: ......