HP AdvanceStack 100VG, Руководство по установке

Страница: 12 / 26

5. Seat the module in the slot by simultaneously raising both extractor
handles to their full vertical position, and pressing them against the
module face plate. Note that the handles will remain a little loose
until you complete step 6.
6. Tighten the captured screw in each handle by using a flat-blade or
Torx-10 screwdriver.
Be careful not to overtighten the screws
.
If the switch has power during module installation, the LEDs will
behave as described on the next page.
If you have not already done
so, install the LED label strip as described in step 1.
raise extractor handles
tighten these two screws
Figure 3. Extractor Handles in the Raised (Closed) Position
Self-test LED
Slot Fault LED
Figure 4. Self-Test and Fault LEDs on the Switch 2000
4