(1) LED for 10/100/1000 Mbps electrical Ethernet interface 0 (GE0)
(2) LED for 10/100/1000 Mbps electrical Ethernet interface 1 (GE1)
(3) Run LED (RUN)
(4) 1000 Mbps optical Ethernet interface LED (SFP1)
(5) 1000 Mbps optical Ethernet interface LED (SFP0)
Table 1-21
Description of FIP
LED
RUN (green)
Off
Slow blinking (1 Hz)
Fast blinking (8 Hz)
SFP0 and SFP1
(yellow/green)
Off
Solid green
Blinking green
Solid yellow
GE0 and GE1
(yellow/green)
Off
Solid green
Blinking green
Solid yellow
Blinking yellow
Slots
An FIP-110 can be inserted in slot 2 or 3 of the
110 provides four MIM slots for some
to 4 from the bottom up and from right to left, as shown in
Figure 1-22
Interface module slots on the FIP
The numbers 1 through 4 in
Figure 1
(1) LED for 10/100/1000 Mbps electrical Ethernet interface 0 (GE0)
(2) LED for 10/100/1000 Mbps electrical Ethernet interface 1 (GE1)
(4) 1000 Mbps optical Ethernet interface LED (SFP1)
Mbps optical Ethernet interface LED (SFP0)
Description of FIP-110 LEDs
Status
Meaning
Off
No power input is available or the FIP
Slow blinking (1 Hz)
The FIP-110 is working normally.
Fast blinking (8 Hz)
Application program is being loaded (in this case, never power
off the device or hot-swap the FIP
may be damaged) or the FIP-110 is not working.
Off
No optical link is present.
Solid green
An optical link is present.
Blinking green
Data is being sent or received at a rate of 1000 Mbps.
Solid yellow
The optical transceiver has failed in POST.
Off
No link is present.
Solid green
A 1000 Mbps link is present.
Blinking green
Data is being received or transmitted at a rate of 1000 Mbps.
Solid yellow
A 10/100 Mbps link is present.
Blinking yellow
Data is being received or transmitted at a rate of 10/100 Mbps.
110 can be inserted in slot 2 or 3 of the A6604 and slot 2, 3, 4, or 5 of the
110 provides four MIM slots for some HP legacy MIMs. The slots on a FIP-110 are numbered 1
to 4 from the bottom up and from right to left, as shown in
Figure 1-22
.
Interface module slots on the FIP-110
Figure 1-22
represent Slot 1 through Slot 4 respectively.
Meaning
No power input is available or the FIP-110 has failed.
110 is working normally.
Application program is being loaded (in this case, never power
swap the FIP-110; otherwise, the FIP-110
110 is not working.
Data is being sent or received at a rate of 1000 Mbps.
The optical transceiver has failed in POST.
Data is being received or transmitted at a rate of 1000 Mbps.
Data is being received or transmitted at a rate of 10/100 Mbps.
and slot 2, 3, 4, or 5 of the A6608. FIP-
110 are numbered 1
1 through Slot 4 respectively.
