HP 8924E, Сборка

Страница: 631 / 640

631
Appendix A, Error Messages
Non-Recoverable Firmware Error
N:\mkt\MANUALS\HP8924C\ALR\errmssg.fb
Non-Recoverable Firmware Error
This error occurs when the Test Set encounters a condition that the firmware doesn’t
understand - causing the Test Set to halt operation until power is cycled. The message
appears in the center of the Test Set’s display and (except for the two lines in the second
paragraph) has the form:
Non-recoverable firmware error. Please record the 2 lines of
text below and contact Hewlett Packard through your local
service center. In the U.S., you may call the factory at
(800) 827-3848.
‘Address error exception’
at line number 0
To continue operation, turn POWER off and back on.
Follow the instructions in the message.
Unfortunately, you may not be able to recover from this condition without turning the
Test Set off. The error may not reoccur when you turn the Test Set back on and rerun the
test where the Error Message first occurred. If the failure reoccurs, you should record
exactly what the configuration of the instrument was when the error appeared, and contact
HP. This information will help us determine the proper course of action for your repair.
If This Error
Occurs at
Power-up
If the Test Set displays this error when first powered up, disabling Test Set
operation, it could be related to the
Autostart
field on the main TESTS screen.
This field causes the Test Set to automatically run the last program loaded in
memory when the Test Set is powered up. If the program is corrupted, the Test Set
will automatically “lock up”.
The only way to recover from this condition is to clear the Test Set’s operating RAM.
This will clear any IBASIC program, Save/Recall registers, and RAM disks that have
been saved, as well as three calibration factors. The calibration factors are easily re-
entered; the IBASIC programs, Save/Recall registers, and RAM disks must be re-loaded
or re-initialized after clearing memory.