HP 8/20q, Руководство CLI

Страница: 125 / 332

8/20q Fibre Channel Switch command line interface guide 125
Modifying the SNMP configuration
To modify the SNMP configuration, enter the
set setup snmp
command in an Admin session. There
are two groups of configuration parameters. One group is common to all traps; the second group is
trap-specific. You can configure both groups of parameters for all SNMP traps, or you can configure the
common and trap-specific parameters separately. See Table 51 for descriptions of the common SNMP
parameters.
The following example sets the common trap parameters for all SNMP traps:
8/20q FC Switch (admin) #> set setup snmp common
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
SnmpEnabled True
Contact <sysContact undefined>
Location <sysLocation undefined>
ReadCommunity public
WriteCommunity private
AuthFailureTrap False
ProxyEnabled True
SNMPv3Enabled False
New Value (press ENTER to not specify value, 'q' to quit):
SnmpEnabled (True / False) :
Contact (string, max=64 chars) :
Location (string, max=64 chars) :
ReadCommunity (string, max=32 chars) :
WriteCommunity (string, max=32 chars) :
AuthFailureTrap (True / False) :
ProxyEnabled (True / False) :
SNMPv3Enabled (True / False) :
Do you want to save and activate this snmp setup? (y/n): [n]