29 of 33
Indesit
Company
Service Manual UK
English
E
Console PCB & Button Assemblies
1.
Remove the console panel (D).
2.
Remove wiring plug - taking note of position.
3.
Remove three securing clips and lift away from the console.
F
Pressure Switch
1.
Remove the table top (A).
2.
Disconnect the wiring connection block and pressure hose.
3.
Carefully unclip bracket from cabinet side and then unclip switch from bracket.
G
Door Seal & Restraint:
1.
Door Seal to Front Panel Fixing
The door seal is fixed to the cabinet front panel by a wire clamp and a small spring. The spring is
normally at the bottom of the door.
Carefully place a small screwdriver into one of the lugs of the spring and by stretching the spring
the wire band can be removed.
2.
Drum Fixing
The door seal is fixed to the drum with a spring band retainer.
H
Door Interlock.
1.
Remove the front fixing band (G1).
Peel the door seal off the front panel, and fold it back into the inner
drum.
3.
Remove 2 screws from the interlock.
4.
The interlock can now be eased out, allowing access to the wiring
connection block and emergency release strap.
5.
Care must be taken to ensure the correct orientation of the wiring
connection plug to prevent seriously damaging the interlock and / or
control board.
I
Door Seal
1.
Remove the table top (A), dispenser drawer (C) and console panel (D).
2.
Remove the door seal restraint (G1), door interlock (H).
3.
Remove the drum door seal restraint (G2) and lift clear.
J
Drive Belt
1.
Remove the table top (A).
2.
Remove the rear access panel (B).
3.
Carefully peel the belt off the motor pulley taking care not to trap fingers and using suitable
protection against sharp edges.
4.
To refit the belt, place it round the motor pulley first, tie-wrap the belt onto the drum pulley, and
rotate the drum from the door aperture to move the belt into position.
5.
Ensure any remaining tie-wraps are removed.
It is essential for continued safety that only a genuine spare is fitted. The belt is electrically
conductive and provides an electrical earth to prevent static built up on the inner drum assembly.
