27 of 33
Indesit
Company
Service Manual UK
English
PROGRAMMING (Using EMIT)
The machine can be programmed via the Emit, using a USB lead (Part number C00222800),
Hardware key (Part number C00115587) and the Memwriter software.
PROGRAMMING (Using Smartcard Reader / Card)
If the Main Module has been replaced during a repair the board will require programming using the
following method.
1.
Select Memwriter programme.
2.
Ensure correct Valid Comport is selected.
3.
Ensure correct Hardware key is selected (Black).
4.
Ensure correct Appliance type is selected (New Platform)
5.
Select Commercial Code.
6.
Open Comm Port (A bright green connection icon will light
on screen).
7.
Click into CODE BOX in "Search Method".
8.
Insert Commercial Code & Serial number.
9.
Click search button.
10. File to download box's will now display machine
information.
11. Click download.
If appliance already has the most up to date file a warning
box will appear indicating EEPROM ALREADY UPDATED
NOTE:
When starting Memwriter programme the default selection
is always GET FROM HARDWARE.
Black Hardware Key
USB - Serial Cable
A Hardware Key Pin is available
(order Part No. C00114723).
1.
Do NOT connect the machine to electrical supply.
2.
Insert the pre-programmed card into the Card
reader. Care must be taken at this point to ensure
the card is inserted correctly with the Chip on the
card facing the PCB of the Reader.
3.
Insert the Reader and Card into module connection
port - see photo.
4.
Connect the machine to the Electrical supply
, the
LEDs on the Smart Card Reader will light in this
sequence:
a)
Red OFF: Good Communication between Smart
Card Reader and Card.
b)
Red OFF; Green Blinking: Download taking place.
c)
At end, Green ON ---> Download OK.
d)
At end, if Red ON ---> Download NOT OK.
5. Programming Complete, disconnect the machine
from the electrical supply.
6. Remove the Smart Card Reader.
Smart Card Reader
and Smart Card in use
