30 of 33
Service Manual UK
Indesit
Company
English
M Lower Balance Weight (with Drum Removed)
1.
Remove the table top (A), dispenser drawer (C) and console panel (D).
2.
Remove the door seal restraint (G), door interlock (H) and drum assembly (V).
3.
Remove three balance weight fixing screws.
4.
Pull the weight forward off its mounting lugs.
K
Door Assembly
1.
Open the door through 180° and remove four screws
securing the hinges to the front panel. Ease the
hinges from the panel.
2.
The door trims can now be split. Lay the door
assembly face down on a suitably protected surface
and remove 6 screws securing the two halves of the
door.
3.
Unclip the two halves at the hinge end and separate a
sufficient distance to slide out the door glass.
4.
When removing the hinges, note the orientation.
To remove, fold hinges inward, slide towards each
other to release other end. See photo.
Reassemble in reverse order.
5.
To fully separate the halves, slide the front away from
the handle.
6.
To remove the handle or latch, slide securing pin out
noting the position of the spring and latch.
Top Hinge removal
(shown below) -
Slide towards lower hinge, twist to the left
and slide up to release.
Lower Hinge removal
- Slide upwards,
twist to the right and slide down to release.
L
Motor
1.
Remove the rear access panel (B) and drive
belt (J).
2.
Disconnect the motor wiring connection plug
and earth wire.
3.
Remove the motor mount fixing screws.
4.
Ease the motor off the drum mountings.
5.
When refitting the motor plug, ensure correct
positioning of the motor plug as shown with
all cables aligned - see Fig. 9.
WRONG
Fig. 8
CORRECT
Fig. 9
wiring colours shown
here may be different
on the appliance
