Hoshizaki IM-50BAA-Q, Руководство по обслуживанию

Страница: 15 / 52

14
D. Bin Control Check and Cleaning
1. Bin Control Check
This appliance uses a lever-actuated proximity switch to control the ice level in the
storage bin. No adjustment is required.
To check, follow the steps below.
1) Remove the front panel and then move the control switch to the "OFF" position.
2) Unplug the appliance.
3) Remove the control box cover. Clear any ice away from BC.
4) Check BC wire harness connections.
5) Disconnect BC wire harness connector from CB CN3 connector.
6) Check for continuity across the wires of BC wire harness connector. When the actuator
paddle is not engaged, BC switch is closed. If open, check that the wire harness
connector is properly connected and that the actuator paddle is not sticking. Clean if
necessary. See "II.D.2. Bin Control Cleaning." If BC switch still reads open, replace BC.
7) Press and hold the actuator paddle; check for continuity across the wires of BC wire
harness connector. When the actuator paddle is engaged, BC switch is open. If closed,
check that the actuator paddle is not restricted. Clean if necessary. See "II.D.2. Bin
Control Cleaning." If BC switch still reads closed, replace BC.
8) Reconnect BC wire harness connector to CB CN3 connector, then move the control
switch to the "ICE" position. Turn on the power supply.
9) Allow the icemaker to cycle on. Press and hold the actuator paddle for at least
10 seconds. The icemaker should shut down. If it does not, replace CB.
Note: If BC is engaged (open) while the water tank is opening after the power supply
is turned on (or after the "RESET" button is pressed), shutdown does not start:
Shutdown occurs 10 seconds after actuator motor's internal position sensor
indicates water tank is fully open.
Legend: BC –bin control; CB –control board
Fig. 1
Bin Control Cable Connector
Actuator Paddle
Switch Mount
Magnet
Thumbscrew
Bin Control Bracket
Bin Control