horsch Partner 1600 FT, Руководство по эксплуатации

Страница: 65 / 69

Working position
Possible values for configuration:
•
“deactivated”: No sensor measures the wor -
king position.
•
“Tail over socket B”: A working position sen -
sor is located at the rear lifting gear or the
implement mounted to the rear lifting gear. It
is connected to the terminal via socket B. The
working position sensor must be configured.
¾
Configure the working position sensor (see
Müller Elektronik operating instructions, p. 58):
The terminal must be told that a digital ISO-com-
patible working position sensor according to
ISO 11786 is used. The sensor is connected to
the terminal via the signal socket.
¾
Procedure:
1. Call up the Tractor-ECU application.
2. Open the vehicle list.
3. Choose vehicle profile
4. Press
5. This screen appears:
6. Select the sensor type “digital”.
7. Select inversion.
8. Return to vehicle profile. Calibration
is completed
HORSCH machine setting
On the last configuration screen, set the speed
source (A) on TECU wheel and the working
position (B) to TECU. If the dots light up red,
the settings in the tractor ECU are wrong and
must be corrected. The settings are correct if
every lights up green, and the working signal
is transferred.
A
B
C O N F I G U R A T I O N
km/h
w o r k i n g p o s i t i o n :
pulses/rev.
min
max
Incorrect setting
C O N F I G U R A T I O N
km/h
w o r k i n g p o s i t i o n :
pulses/rev.
min
max
Target state
It is sufficient for the function of the cable bet -
ween HORSCH machine and tractor to either
set the configuration of one sensor (speed or
working position) or of both sensors.
60 61