horsch Maestro SW 1630, Руководство пользователя

Страница: 109 / 132

Maestro SW Owner’s Manual – Ver. 2.4 11/2018 109
www.horsch.com
7. Lightly grease machined surface of center pivot pin and insert into the receiver end of the axle.
Rotate the pin to align the rear mounting hole in the receiver pin. Install the bolt and locknut
provided with the kit. Tighten pin bolt.
8. Install the inner thrust washer against the axle pin flange.
9. Apply a light amount of grease to the center pivot pin.
10. Slide the undercarriage onto the axle pin.
NOTE: Care must be exercised to avoid damage to the lip seals on the center bore of the
undercarriage assemblies during installation. Using a fork truck, lift the undercarriage
assembly onto the center pivot pin.
11. Install outer thrust washer, retaining cap and retainer cap bolts & washers. Torque retainer bolts
to 620 N-m +/- 124 N-m (457 ft-lbs +/- 91 ft-lbs).
12. Repeat steps 7 through 11 for the other side of the axle assembly.
13. Remove any jack stands or supports and lower the implement to the ground.
Grease this
surface
WARNING
Make sure undercarriage is installed with track tensioner assembly
(spring) positioned to the rear of implement. DO NOT install the track
system with the tensioner positioned to the front of the implement.