horsch Focus 7 MT, Руководство по эксплуатации, Страница: 59 / 78

4. Press the conical nut against the outside
screw (e). Do not use a hammer, or similar!
5. Lubricate the external thread with grease or
copper paste.
6. Screw the bearing with the outside screw onto
the shaft (tightening torque 370 ± 20 Nm).
7. Tighten the inside screw (tightening torque
180 ± 20 Nm).
Pull out the screw if it cannot be tightened
and press the conical nut against the outside
screw.
g
f
8. Bolt the packer shaft together with the spac-
er (f) to the side arm (g)
Dismantling the packer
WARNING
Dropping or rolling machine parts can cause
severe crushing injuries etc.!
¾
Support the raised machine by appropriate
means and secure the packer against rolling
away.
¾
Comply with the accident prevention instruc-
tions.
Perform this action on all packer bearings:
a
c
b
1. Remove the screws (a) and detach the
packer from the side arm (b).
2. Remove the spacer (c).
d
e
3. Unscrew the inside screw (d) for about 1 cm.
4. Knock the screw inward to detach the conical
nut from the outside screw (e).
55