HornBlasters NATHAN AIRCHIME, Руководство по установке

Страница: 7 / 17

Preparing the Air Compressors
•
                  
•
                  
                    

•
                   

Barb Fittings
(Male & Female)
Filter Housing
Relocation Air Line
www.hornblasters.com support@hornblasters.com
Start by locating the hardware that was packaged with your air compressor s . You should have a set of mounting
bolts, two barb fittings, and an air filter housing for each . A picture of each is shown to the left for reference.
Let’s start by taking the fitting on the left with the male thread and inserting it into the
compressor inlet. The other fitting (female end) can be threaded onto the filter housing
directly. Your compressor/filter should look like the image below. At this point, you can
use the supplied air line
that was packaged with the compressor to connect the
compressor and filter together.
Repeat this for all 4 compressors.
**This line is not meant to hold pressure. Do not use this for anything other than
the filter.
Connect fittings to
compressor & filter
Route 3/8" air line in
between filter/compressor
Filter Placement
Your compressor is fully sealed against the elements. If the compressor is mounted outside with the air filter on
the end of the compressor, the filter will get wet and water will get pulled into the compressor. To prevent this,
the filter must be relocated to an
ENCLOSED AND DRY location. If your compressor is mounted in the bed of
your truck or underneath the bed, the filter could be relocated into the cab of the vehicle. The filter must be
relocated to an area where it will not be exposed to debris or moisture.
If the air filter is not relocated, the compressor will pull in water/dirt and will stop working properly. 9
out of 10 compressors that fail within the first year have pulled in water/debris from the intake.
WE DO NOT WARRANTY COMPRESSORS THAT HAVE FAILED DUE TO WATER/DEBRIS
BEING PULLED INTO THE INTAKE/FILTER
Page 7