HornBlasters NATHAN AIRCHIME, Руководство по установке

Страница: 14 / 17

Plumbing the Drain Valve Kit
•
                  
•
                  
                    

•
                   
support@hornblasters.com
Locate the stainless steel 3/8" valve that was packed with your kit. The box reads
'SV-777-10'. Take a look at each port on the valve and locate the arrow. It should be
directly above the female port on one side of the valve.
Take note of this arrow as it indicates the direction of flow for the valve. Go ahead and
locate the roll of 3/8" DOT air line that was included with the kit, as well as the baggy
containing a push button, wire, and a brass fitting.
Start by threading the 3/8" NPT x 3/8" PTC fitting into the inlet side of this solenoid valve. The outlet is the port
the arrow faces towards, so this fitting will be plumbed on the port opposite the direction the arrow faces.
Inlet
Outlet
Locate the 3/8" NPT x 1/4" FNPT reducer bushing that was
packed with the other drain valve components. Go ahead
and thread this fitting into the outlet of the valve, or the side
the arrow points towards. This will slow down the flow of air
so that you don't dump all of the air through this valve.
Finally, locate the roll of 3/8" line that was packed with the
drain valve components. Run this line from the elbow fitting
on the bottom of the tank to the inlet side of this valve. Make
sure each end of the line is cut straight and flush. (refer
back to page
10)
Page 14