HornBlasters NATHAN AIRCHIME, Руководство по установке

Страница: 13 / 17

6511 N 54th St
Tampa , FL 33 610
+1 (877) 209-8179 Fax:
+1 (813) 783-2407
A Units type: Pressure Per Square Inch (PSI)
B. Air pressure gauge display: digital type 0 ~ 200 psi ; analog led 0 ~ 200 psi
C. If pressure exceeds the display range, digital display will show psi of 200 psi
D. If air pressure PSI is higher than 200 psi for 3 sec or more, the digital number will flash for warning
E. LED analog indicator (there are 20 pcs of led light around the side)
www.hornblasters.com sales@hornblasters.com
ELECTRIC AIR PRESSURE GAUGE
0~100 psi 101~150 psi 151~200 psi
Red led x 10 pcs Yellow led x 5 pcs Green color x 5 pcs
Fun
ction:
• Turn on and turn off the engine: red, yellow, and green led will scan once.
• Display voltage of battery fuction: Turn ignition key to run, display battery voltage for 60 sec.
• Display fucton: Display air pressure value, number and led color will correspond.
Air P ressure S ensor
Installation instructions:
Black - air press sensor wire (black)
Green - air press sensor wire (green)
Brown - air press sensor wire (brown)
Do not over tighten sensor (12-14 ft/lbs)
Air P ressure Gauge
Installation instructions:
Red - Connect to 12V Ingition Positive
(Keyed Power On)
Yellow - Connect to Battery Positive (+)
Black - Connect to Ground (-)
(Splits into two separate
leads, ground both to the same point)
Green - Connect to air pressure sensor green
wire
Brown - Connect to air pressure sensor brown wire
Left switch up: US (psi) - If your gauge only reads 10-13 PSI, it is
likely set to read BAR instead.
Left switch down: Metric (bar)
Right switch up: voltage display ON Right switch down: voltage display
OFF
Page 13