HornBlasters NATHAN AIRCHIME, Руководство по установке

Страница: 9 / 17

Recommended Tank Assembly
The fittings on each end of
the tank can be reversed to
opposite ends if needed.
<< >>
Make sure to use teflon tape
on ALL fittings when plumbing
them into the tank!
The fitting on the bottom of
the tank (between the legs)
must be threaded in as far as
you can get it. This fitting will
not clear the mounting
surface unless it is threaded
in ALL THE WAY.
This assembly show a fitting configuration if
you plan to mount the tank upright. If you
plan to mount the tank upside down, an
elbow will be need to relocate the pressure
switch. When mounting upside down, the
pressure switch and elbow fitting on the
bottom will be reversed (switch sides) and
the pressure switch is too tall to clear the
legs of the tank, if you mount this on a flat
surface.
Right End Port
Left End Port
Safety Blowoff
Valve
Outlet
fitting for
1/2" line
to horns
1/2" x 1/4"
Reducer
Page 9
Air Gauge + Dig.
Gauge Sending Unit
1/4" Run Tee 1/4" Run Tee
3/4" x 1/2"
R 1/2"
x 1/4" Reducer
Electric Drain Valve
Outlet
Pressure
1/2" x 1/8" Reducer
1/2" x 1/4" R 1/4" Run
Tee
< 1/2" x 1/4"
Reducer >
Tire Inflation Kit
Outlet