HornBlasters NATHAN AIRCHIME, Руководство по установке

Страница: 5 / 17

Assembling the Horn
S
Start by locating the manifold for the horn assembly. A picture of the manifold is shown below. This manifold
will hold all five horn bells together in a flat configuration. The order in which the horns are assembled to the
bracket does not matter. You can have a couple facing forward with the rest backward, in any order.
Each horn bell will use two bolts and two split lock-washers to mount to the manifold. The bolt/washer
can be seen to the right.
Before you mount the bells to the manifold, make sure to insert an O-ring into each bell's inlet to ensure
a proper seal. The image below on the left shows this step.
Make sure that the O-ring is firmly seated into the groove on the bell. This prevents excess air from
escaping before it enters the horn and makes a sound.
Secure each horn bell to the manifold using a bolt/lock-washer on each side of the horn bell. Tighten
each bolt down with a 9/16" wrench until the lock washer is crushed. Do not leave these bolts loose!
START EACH BOLT BY HAND. DO NOT START THESE BOLTS WITH A WRENCH AND RUN THE
RISK OF CROSS-THREADING THEM, RENDERING THE MANIFOLD UNUSABLE.
O-Ring Example
Mounting Hardware
Page 5