222DS BENCHTOP SHAKING INCUBATOR
Quick Guide
Page 1
1.
BASIC OPERATION
Press POWER switch on control panel. Shaking incubator automatically
detects power supply frequency F50 or F60 and shows it on display. Likewise
the shaking incubator is then set to last saved parameters.
Press and hold encoder knob for more than 2 seconds. Temperature
signal light blinks. With rotating encoder clockwise (+) or counter-clockwise (-),
set temperature to desired value.
If you want to use the shaking incubator
without temperature regulation
-
set OFF on display. You get OFF function on display, when you rotate encoder
under 0.0°C or above 70.0°C.
Press encoder knob.
Speed
signal light blinks. With rotating encoder clockwise (+) or counter-
clockwise (-), set rotating speed to desired value.
If you want to use the shaking incubator
without shaking
- set OFF on
display. You get OFF function on display, when you rotate encoder under 20
RPM or above 300 RPM.
Press encoder knob.
Time
signal light blinks. With rotating encoder clockwise (+) or counter-
clockwise (-), set time to desired value from 1 min to 99 h.
If you want to set
Time
to
hold
(continued operation) - set HLd on display.
You get HLd function on display, when you rotate encoder under 0.01 min or
above 99.0 h.
Press START/STOP key once
to exit the changing of parameters. You are
now in starting mode. Only signal light of the last changed parameter shines.
Note: You always change the parameter, whose signal light blinks -
temperature, speed or time. You can always change one, two or three
parameters. To exit the changing of parameters, always press
START/STOP key once.
Press START/STOP key to start the operation.
Run
signal light shines. Shaking incubator counts down the time from set
value.
You can move between the values of time and speed during the operation, by
pressing the encoder. These two values are shown alternately on bottom display.
