HTTP/HTTPS
W
EB
GUI
–
W
EB
B
ROWSER
C
ONFIGURATION
I
NTERFACE
7052RC Network Management Server - V01.00
81 / 98
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
The following errors are displayed:
Error No.
System
7001RC
Error Type
Meaning
ERROR-01
Invalid System Time
System time valid / invalid
ERROR-02
System not synchronous
System status is synchronous / not synchro-
nous
ERROR-03
SyncOFF Timer active
SyncOFF Timer running / not running
ERROR-04
SyncON Timer active
SyncON Timer running / not running
ERROR-05
Monitoring Error
RC function board operated in "Monitoring
Mode" reports an error message
ERROR-06
Mains Frequency Error
RC function board 7515RC operated in "Moni-
toring Mode" reports a Mains Frequency error
ERROR-07
Line Error
RC function board 74065RC operated in "Moni-
toring Mode" reports Line error
ERROR-08
Idle Error
RC function board operated in "Idle Mode" re-
ports error message. Possible reasons: Failure
of t the appropriate boards or card-specific er-
rors (line error, mains frequency error or NTP
accuracy < high / medium message).
ERROR-09
Control of the internal Crystal Basis
Error / no error in the control of the internal
crystal basis
ERROR-10
Keypad active
Access via remote interface possible / not pos-
sible
ERROR-11
NTP accuracy lower than high
RC function board, operated in "Monitoring
Mode", reports "NTP accuracy < high"
ERROR-12
NTP accuracy lower than medium
RC function board, operated in "Monitoring
Mode", reports "NTP accuracy < medium"
ERROR-13
Sync-Status Primary Source
Primary synchronisation source for synchroni-
sation is available / not available
ERROR-14
Sync-Status Secondary Source
Secondary synchronisation source for synchro-
nisation is available / not available
Card-specific Errors:
1. Card-specific errors are reported by the relevant boards. If there is a board failure, not the
card-specific errors are reported but the error of the appropriate board!
2. Card-specific errors are only reported separately if the relevant board runs in "Monitoring
Mode". Otherwise the Idle error is activated.
Example: If a board 7406RC fails which runs in "Monitoring Mode" the Monitoring Error
(ERROR-05) will be reported but no Line Error (ERROR-07)!
