Hoover FloorMate, SpinScrub Floor Mate Spin Scrub Hard Floor Cleaner, Инструкция пользователя

Страница: 4 / 134

G
1-3
1-6
1-4
1-5
With cord hook (B) to back of cleaner,
push upper handle down onto cleaner.
Insert screw with washer in front of
tank area. Tighten screw with a
Phillips screwdriver.
Replace clean solution tank by posi-
tioning bottom first. Press latch and
snap top portion into place.
Insert two screws into back of handle
as shown. Tighten with a Phillips
screwdriver.
4
B
C
1-7 1-8
E
D
To install brushes, place handle in
upright position. Tilt cleaner back so
that it rests on the floor.
Align post (D) on brush block with
hole (E) on bottom of cleaner. Turn
brushes slightly until post fits easily
into hole. Press brush assembly firmly to snap
into place.
1-9
H
F
F
To install nozzle, make sure latches
(F) are out.
Align middle section (G) of nozzle
with opening (H) on cleaner.
Remove cardboard packing insert
from squeegee area on underside of
nozzle.
While holding nozzle in place, slide
latches inward to lock in place.
1-10 1-11
Push brush control switch (C) down to
connect switch rod. You will hear a
“click” when the switch rod is in
place.
Cord clip
To help keep the cord out of the way
while cleaning, position cord down
into cord clip (I), located on the
handle.
I
GB
FM-Candy final 17/6/03 4:54 PM Page 4