Rev. 1.0
31
900.0688
9-Dec-05
8.11 LOADING THE CHANGES INTO THE HMXAT200 CONTROLLER
To load the revised configuration into the HMXAT200 System Controller, perform the
following steps.
1. Remove the floppy disk (with the saved changes) from your PC and place it into the
floppy drive of the HMXAT200 System Controller.
2. Depress the green reset button (behind the front cover) on the HMXAT200. This will
automatically copy the updated configuration files to the hard-drive of the
HMXAT200.
3. Wait for the LED on the floppy disk drive to extinguish before proceeding.
4. Remove the floppy disk from the drive and depress the green reset button once
again to re-boot the HMXAT200 System Controller to the new configuration.
Note:
The system will not run with the floppy disk still in the floppy-drive.
5. Store the floppy disk in a safe place.
The miniMAX system is now operational. If you are starting the system for the first time,
the time and date will need to be set to your local time.
