Rev. 1.0
12
900.0688
9-Dec-05
SECTION 5:
HEGS5300
5.1
SETTING UP THE HEGS5300 KEYBOARD
HEGS5300 keyboards are setup using the keyboard keys. There are three (3)
user-defined settings. These are:
•
Keyboard ID – valid ID’s 1 to 99. (Default = ID 1).
•
Baud Rate – 19K2 or 9600. (Default = 19K2. Data format is fixed at 7 data bits,
1 stop bit, even parity).
•
Joystick speed range – There are 2 ranges of pan/tilt speeds from the analogue
joystick. The default is a range of 5 speeds (0=STOP to 5=Maximum speed). The
alternative is a range of 26. As before 0=STOP, but the speeds generated are from A
(slowest) through to Z (fastest). Speed Z is equivalent to speed 5, in that it is
generated when the joystick is at its maximum pan or tilt position. This feature is
available when using MAX1000, version 4.27 or later.
To enter the SETUP MODE hold down the MENU
key or the
½
key (to the left-
hand-side of the LCD) as the keyboard is powered up.
Note
: If the keyboard has a custom overlay, the MENU key may be located in a different
position. Therefore, using the
½
key next to the LCD is always a preferred option.
Once in the setup mode, the LCD prompts the user to enter the required information
using the numeric keypad. Pressing the enter key (
↵
) or the
¾
key moves to the next
stage. Pressing the
½
key goes back to the previous setup screen.
When the keyboard ID, baud rate, and joystick speed range have been entered, the final
setup stage stores the settings and the joystick reference position. The keyboard should
be flat on the desk when pressing the enter key (
↵
) at this final stage to ensure the
joystick is zeroed. Setup information is stored in non-volatile memory so the settings will
be retained if the keyboard is unplugged.
