Lyric Controller Installation and Reference Guide
- 29 -
Testing the System
Testing the System
Testing the System
Testing the System (Continued)
(Continued)
(Continued)
(Continued)
Zone Discovery
Zone Discovery
Zone Discovery
Zone Discovery Mode
Mode
Mode
Mode
Zone Discover
Zone Discover
Zone Discover
Zone Discovery mode requires Installer supervision when in use. The system is not fully operational
y mode requires Installer supervision when in use. The system is not fully operational
y mode requires Installer supervision when in use. The system is not fully operational
y mode requires Installer supervision when in use. The system is not fully operational
for fire or life safety while Zone Discovery Mode is active.
for fire or life safety while Zone Discovery Mode is active.
for fire or life safety while Zone Discovery Mode is active.
for fire or life safety while Zone Discovery Mode is active.
Zone discovery mode can be used to remotely view all zones that have been programmed in the system for
operation. The zones must have a response type programmed. All programmed zones will be displayed.
Enter Zone Discovery
Enter Zone Discovery
Enter Zone Discovery
Enter Zone Discovery
1. With the System in the Installer Programming mode, select the “Test” button and then select the “Zone
Discovery” button. The “Zone Discovery” button will be highlighted indicating that the mode is active.
Exit Zone Discovery
Exit Zone Discovery
Exit Zone Discovery
Exit Zone Discovery
1.
Select the Home key and enter the Master Code. If you do not exit Zone Discovery mode manually, the
system will automatically exit zone discovery mode in approximately 1-4 minutes dependent upon the
number of zones that are programmed. The system beeps once and returns to the home screen.
Rebooting the System
Rebooting the System
Rebooting the System
Rebooting the System
The Reboot function allows you to restart the system if required. To reboot the system perform the following:
1.
With the System in the Installer Programming mode, select the “Test” button and then select the
“Diagnostics” button.
2. The system advances to the next screen. Select the “Reboot” button. A confirmation screen appears.
3. Select “Yes”. The system will restart.
Note:
Note:
Note:
Note: After the reboot sequence is complete it is recommended that you perform a “Walk Test” to verify that
all transmitters are operational in the system.
.
