Honeywell HRSD16, Руководство пользователя

Страница: 29 / 176

Installation
Document 800-03650 Rev D 29
02/09
Factory Reset
The DVR has a Factory Reset switch to the left of the Alarm Output connectors on the
rear panel. This switch should be used only on the rare occasions that you want to
return all the settings to the original factory settings.
Figure 2-14 Factory Reset Switch
Caution When you use the Factory Reset, you lose any settings you have
saved.
To reset the unit, you need a straightened paperclip:
1. Turn off the DVR.
2. Turn it on again.
3. While the DVR is initializing, the front panel LEDs blink. When the front panel LEDs
blink, poke the straightened paperclip to the unlabeled hole in the left of the Alarm
Output connectors.
4. Hold the switch until all the LEDs on the front panel are lit.
Note When the DVR successfully resets to factory defaults all the LEDs
on the front panel flash five times.
5. Release the reset switch. All of the DVR's settings are now at the original settings it
had when it left the factory.
Connecting the Power Cord
Connect the AC power cord to the DVR and then to a wall outlet.
Figure 2-15 Power Cord Connector