40
107063-11 EN FR26 GLO 800 Printed in France
3.
The laser pen and its mechanical must be used for an easy installation. They can be
installed on the top and rear of each column.
•
Install the laser pen and its mechanical adapter on one of the 2 columns and adjust
its orientation to get the laser red spot closed to the laser location hole available on
the opposite column.
If the red spot is located ABOVE (or UNDER) the opposite location hole, then the column must
be slightly leaned FORWARD (or BACKWARD) untill the red spot meets the location hole:
If the red spot is located on the RIGHT (or LEFT) of the opposite location hole, then the
column must be slightly leaned on the LEFT (or RIGHT) untill the red spot meets the location
hole:
•
Carry out the same operation with the laser pen installed on the opposite column.
Correct beam alignment is achieved when the signal margin LED available on each
FF-SPS4 receiver gets Off.
Mechanical adapter
Laser pen
Column
Adjustment screws
Backward
Forward
Bad
Good
Bad
Adjustment screws
Left
Right
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from