44
107063-11 EN FR26 GLO 800 Printed in France
Figure 3-2 Quick-connect Connector Pinouts
Receiver
Emitter
Terminal Strip Connector Wiring
(see figure 3-3)
The terminal strip is a plastic connector. To ensure compliance with the rated sealing, install
only one cable through the connector and attach firmly (see figures 3-3, 3-4, 3-5 and 3-6).
CONNECTOR DAMAGE
To prevent irreversible connector damage, do NOT pull on wires during removal. Always push
the orange tab first before removing a wire.
Failure to comply with these instructions may result in product damage.
ELECTRICAL NOISE IMMUNITY
To ensure the specified immunity to electrical noise, the ground terminal of FF-SPS4 must be
connected to the main ground of the machine.
The following tools are necessary:
•
A set of wire strippers.
•
A small-sized, flat-head screwdriver.
•
A Torx T15 screwdriver.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from