Honeywell C7024E, Руководство пользователя

Страница: 7 / 16

7 65-0156—1
C7024E,F
INSTALLATION
Fig. 6—Vertical Mounting of C7024E,F Detectors.
COMBUSTION
CHAMBER WALL
M1964A
BURNER
C7024E, F SIGHTING
VERTICALLY DOWNWARD
C7024E, F SIGHTING
VERTICALLY UPWARD
Fig. 7—C7024E,F mounting positions.
The C7024E has notch and arrow indicators (see Fig. 7)
on the faceplate to facilitate mounting in positions other
than those shown in Fig. 6. The notch and arrow must be
vertically aligned with the notch in the up position and the
arrow pointing downward. The C7024F must be mounted
with the conduit opening located approximately 45 de-
grees below the horizontal (see Fig. 7).
IMPORTANT: The notch and arrow on the C7024E
faceplate must be aligned in a vertical plane with
the notch up and the arrow pointing downward.
The C7024F housing must be mounted with the conduit
opening approximately 45
°
below horizontal (see Fig. 7).
Fig. 8—Mounting C7024E Detector.
COVER
M1959A
ROTATE DETECTOR
THIS WAY WHEN MOUNTING
ROTATE DETECTOR THIS WAY
TO SEPARATE MOUNTING FLANGE
CAPTIVE COVER SCREW (4)
FACEPLATE
BACK SECTION OF
MOUNTING FLANGE
NOTCH IN FACEPLATE
(C7024E ONLY) 120934 (3/4 INCH NPT)
FRONT SECTION OF
MOUNTING FLANGE
SCREW ONTO
SIGHT
PIPE
SLOT (3)
FLANGE
SCREWS (3)
To mount a C7024E (see Fig. 8):
1. The mounting flange is in two pieces. Loosen, but
do not remove, the three screws holding the flange
together.
2. Slightly rotate the detector so the slots in the back
section of the mounting flange clear the screws in the
front section, then separate the two sections.
3. Screw the front section of the mounting flange
onto the sight pipe, reducer, or other fitting.
4. Fit the slots in the back section of the mounting
flange (with the detector) over the three screws in the
front section, and rotate the detector so that the screws
hold the flange together.
5. Securely tighten the screws.
To mount a C7024F with explosion-proof housing
(see Fig. 9):
1. Unscrew the collar on the pipe union and remove
the coupling section. The collar and coupling are in two
pieces; do not separate them.
2. Screw the coupling onto the sight pipe, reducer, or
other fitting.
3. Mount the rest of the pipe union (with the detec-
tor) on the coupling and securely tighten the collar.
M1965A
C7024E, F MAY BE MOUNTED
HORIZONTAL, VERTICAL, OR
AT ANY ANGLE IN BETWEEN
HORIZONTZAL
PLANE
VERTICAL
PLANE
90°
90°
1
1
1
NOTCH IN FACEPLATE
MUST BE UP
HORIZONTAL
PLANE
NOTCH AND ARROW
MUST ALWAYS BE
ALIGNED IN A
VERTICAL PLANE
C7024E OR F
MUST NOT
BE ROTATED
AROUND
ITS AXIS
ARROW ON FACEPLATE
MUST BE POINTING
DOWNWARD
45°
C7024F CONDUIT
OPENING POSITION
ADE IN U.S.A.
MOUNT WITH
ARROW DOWN
1
NOTE DOWNWARD
POSITIONING OF
CONDUIT OPENING.