Honda WX15T, Руководство пользователя

Страница: 93 / 100

12-2
dummyhead dummyhead
CYLINDER HEAD
CYLINDER HEAD
CYLINDER HEAD COVER/VALVE
REMOVAL/INSTALLATION
Set the piston at top dead center of the compression
stroke.
• After installation, inspect the following:
– Valve clearance (page 3-8) .
– Cylinder compression (page 12-3) .
ROCKER ARM SHAFT
CYLINDER HEAD COVER
FUEL TANK STAY
REMOVAL:
Push down and slide the
retainer to the side, so the
valve stem slips through the
hole at the side of the
retainer.
VALVE SPRING (2)
SPARK PLUG
VALVE STEM SEAL
(INTAKE)
ROCKER ARM (2)
VALVE ADJUSTING
SCREW (2)
VALVE SPRING RETAINER (2)
INSTALLATION: ( page 12-3 )
When removing the cylinder head cover, pry
off slowly at each corner of the head cover.
Do not remove the cylinder head cover with
force.
Replace the cylinder head cover if it is
deformed.
INTAKE VALVE
INSTALLATION:
Before installation, remove carbon
deposits and inspect the valve.
VALVE HEAD DIAMETER:
17.5 mm (0.69 in)
EXHAUST VALVE
INSTALLATION:
Before installation, remove carbon
deposits and inspect the valve.
VALVE HEAD DIAMETER:
15.5 mm (0.61 in)
PUSH ROD (2)
BOLT (5 x 12 mm) (4)
5.9 N·m (0.6 kgf·m, 4.3lbf·ft)
VALVE ADJUSTING
SCREW LOCK NUT (2)
5.4 N·m (0.55 kgf·m, 4.0 lbf·ft)
( Entire surface )
( Sliding surface
and stem end
)
( Sliding surface
and stem end )
( Entire surface )
( Journal and pivot )