Honda WX15T, Руководство пользователя

Страница: 34 / 100

4-3
dummyhead dummyhead
TROUBLESHOOTING
ENGINE WON’T START
• Check the oil level before troubleshooting (page 3-4) .
Compression
is too high
Compression
is too low
Check the cylinder compression
(page 12-3)
.
Check the valve clearance (page 3-8) and then
perform the cylinder compression test. If the
cylinder compression is too high, remove carbon
deposits in the combustion chamber
(page 3-9) .
Check the valve clearance (page 3-8) , and then
perform the cylinder compression test.
If the cylinder compression is too low, perform a
leak down test.
If there is no air leakage in the engine, check the
following.
- Valve spring free length
(page 12-4)
- Piston ring side clearance
(page 11-11)
- Piston ring width (page 11-11)
- Piston ring end gap (page 11-12)
- Piston skirt O.D.
(page 11-10)
- Cylinder sleeve I.D. (page 11-10)
Disassemble the carburetor to clean the
carburetor parts, jets and nozzles
(page 5-6)
.
Wet
Spark
No spark
Fuel
No fuel
Perform the spark test (page 7-7) .
Check the spark plug
(page 3-6)
.
Loosen the carburetor drain screw and check the
fuel flow from the fuel tank
(page 5-6)
.
If spark plug is correct, clean and dry the
electrodes and then restart the engine, taking care
that the choke valve is not closed too much.
If the engine does not start and the electrodes are
wet again, check the carburetor float valve
(page 5-6)
.
Perform the IGNITION SYSTEM
TROUBLESHOOTING
(page 7-2) .
Check for clogged fuel tank joint or fuel tube
(page 5-3)
.
Dry