Honda HS1132, Инструкции дилера

Страница: 7 / 18

HS624 • HS724 • HS828 • HS928 • HS1132 SNOWBLOWERS
7 of 17
UNCRATING
1. Remove and discard the crate top frame, side, and braces.
2. Remove and discard the shipping braces from the auger housing, track guides, engine bed side plates,
track adjusting bar, and/or handlebar assembly.
All models except HS1132:
See ASSEMBLY step 1 and reinstall the two 8 x 14 mm flange bolts in the track guides or engine bed side
plates.
Tighten the 8 x 14 mm flange bolts to a torque value of 22 N•m (16 ft-lb).
3. After assembly is completed, push the snowblower off the crate base.
You can drive the snowblower off the crate base after adding fuel and oil in pre-delivery service.
a. All track-driven models except HS1132:
Bend the crate’s forward track stops flat against the crate base. Step on the height adjustment pedal,
and push down on the handlebar to raise the auger housing to the highest position.
b. Move the transmission release lever to the RELEASED position for manual pushing or to the
ENGAGED position for self-propelled use.
c. Move the snowblower forward, off the crate base. Keep downward pressure on the handle bars to
avoid catching the scraper bar on the crate base.
ASSEMBLY
1. All models except HS1132
Reinstall the two 8 x 14 mm flange bolts that
were removed from the track guides or
engine bed side plate during uncrating.
Tighten the 8 x 14 mm flange bolts to the
specified torque.
TORQUE: 22 N•m (16 ft-lb)
TRACK-TYPE
(EXCEPT
HS1132)
8 x 14 mm
FLANGE BOLT (2)
TRACK GUIDE
WHEEL-
TYPES
ENGINE BED
SIDE PLATE
8 x 14 mm
FLANGE
BOLT (2)