Honda HS1132, Инструкции дилера

Страница: 10 / 18

HS624 • HS724 • HS828 • HS928 • HS1132 SNOWBLOWERS
10 of 17
7. Install the chute crank assembly.
Except HS724 Track-driven model:
a. Remove the saddle-head bolt from the
right handlebar and strut.
b. Install the rear chute crank bracket on the
handlebar, and secure the bracket with
the saddle-head bolt, curved square
washer, and 8 mm flange nut.
HS724 Track-driven model only:
a. Install the rear chute crank bracket on the
upper mounting hole of the handlebar.
b. Secure the bracket with saddle-head bolt,
curved square washer, and 8 mm flange
nut.
Except HS1132
a. Install the middle chute crank bracket so
it holds the auger clutch cable and drive
clutch cable against the fuel tank, as
shown.
b. Secure the bracket with the 6 x 12 mm
flange bolt.
HS1132 only:
Before attaching the middle chute crank
bracket, be sure the chute crank shaft is
positioned on the inner side of the work-light
bracket.
a. Route the chute guide cable over the
middle chute crank bracket.
Do not clamp the chute guide cable
against the fuel tank.
b. Clamp the clutch cables with the bracket
using the 6 x 18 mm flange bolt.
c. Route the work-light wire below the
spacer on the middle chute crank
bracket.
d. Install the front chute crank bracket using
the 8 mm flat washer and 8 mm flange
nut.
Before tightening the nuts, position the
chute crank gear to provide 0.5 - 1.0 mm
(0.02 - 0.04 in) backlash.
e. Tighten the nuts and bolts to the specified
torque:
TORQUE N•m ft-lb
6 mm flange bolt 11 8.0
8 mm flange nut 22 16.0
8 x 41 mm
SADDLE-
HEAD BOLT
8 mm CURVED
SQUARE WASHER (2)
8 mm FLANGE NUT (2)
CHUTE
CRANK
ASSEMBLY
REAR CHUTE
CRANK
BRACKET
8 mm FLAT
WASHER
8 mm
FLANGE
NUT (2)
6 x 12 mm
FLANGE
BOLT
CHUTE
CRANK
GEAR
HS1132 ONLY
6 x 9 mm SPACER
6 x 18 mm
FLANGE
BOLT
CHUTE CRANK
ASSEMBLY