Honda HS1132, Инструкции дилера

Страница: 13 / 18

HS624 • HS724 • HS828 • HS928 • HS1132 SNOWBLOWERS
13 of 17
2. Check the hydrostatic transmission fluid level while the
engine is cold.
If necessary, fill the transmission reservoir to the
temperature compensated level shown in the following table
by removing the reservoir cap and cup.
Use only Honda Hydrostatic Fluid. P/N 08208-HST01
Install the reservoir cap and cup. Do not over-tighten the
cap.
3. Check the auger transmission oil and fill until oil runs out the
drain bolt hole.
Use SAE 90 gear oil.
Part number: 08739-90W
4. Drain the fuel tank and the carburetor float bowl. Fill the fuel
tank with fresh, unleaded 86 pump octane or higher gasoline.
Refer to the owner's manual for facts about oxygenated fuels.
5. Wheel-types: Check tire air pressures and inflate to 8.5 psi
(59 kpa) if necessary.
NOTICE
Over-inflating the tires may damage the tires which may cause the
snowblower to pull to one side. Do not over-inflate the tires.
Ambient
Temperature
Fluid Level
20°C (68°F) Midway between UPPER and LOWER levels.
10°C (50°F) Approximately 2 mm above LOWER level
O°C (32°F) Approximately 1 mm below LOWER level
-10°C (14°F) Approximately 4 mm below LOWER level
B
WARNING
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when handling
fuel.
• Stop engine and keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
UPPER
LIMIT
LOWER
LIMIT
20°C (68°F)
10°C (50°F)
O°C (32°F)
-10°C (14°F)
RESERVOIR
CAP
RESERVOIR
CUP
TRANSMISSION
RESERVOIR
UPPER LEVEL BOLT
DRAIN KNOB
NEW