HS624 • HS724 • HS828 • HS928 • HS1132 SNOWBLOWERS
12 of 17
10.
All models except HS1132:
a. Fasten the auger housing ends of the scraper bar using
the two 8 x 16 mm bolt-washers.
b. Tighten the two 8 x 16 mm bolt-washers to the specified
torque.
TORQUE: 22 N•m (16 ft-lb)
11.
HS724WA: SZBE-1054830 ~ subsequent only
HS928WA/WAS: SZAS-1185559 ~ subsequent only
Install the two side skid shoes using the four 8 x 16 mm bolt-
washers.
Leave the rear skid shoes installed. Adjust the rear skid
shoes, side skid shoes, and the scraper bar in step 6 on
page 14.
12. Put the key in the engine switch. You will find the key tied to
the throttle lever bracket, under the control panel.
PRE-DELIVERY INSPECTION CHECKLIST
Refer to the owner’s manual or shop manual for more
detailed procedures if necessary.
1. The snowblower is shipped
WITHOUT ENGINE
OIL
.
Remove the filler cap/dipstick and add oil to bring
the level to the upper limit.
Do not overfill. If the engine is overfilled, the excess
oil may get transferred out the crankcase breather
hose.
Use SAE 5W-30 engine oil with an API rating of SJ
or later.
8 x 16 mm BOLT-WASHER (2)
8 x 16 mm BOLT-WASHER (2)
SKID SHOE (2)
ENGINE SWITCH
KEY
UPPER LIMIT
LOWER LIMIT
UPPER LIMIT
OIL FILLER
CAP/DIPSTICK
UPPER LIMIT
HS928 • HS1132
HS724
Содержание HS1132
Страница 18: ......
