Honda EU3000i Handi, Руководство пользователя

Страница: 93 / 194

FUEL SYSTEM
6-20
Switch the engine switch knob (1) to CHOKE.
Confirm that the choke cable (2) is pulled to the
direction shown by the choke arm (3).
Confirm that the projection of the switch cam tension
plate (4) is placed in the groove (5) of the engine switch
cam.
Confirm that the choke lever (1) is fully closed when
pulled by the choke cable (2). Then, turn the choke
lever counterclockwise and confirm that it is not loose.
If it is loose, loosen the 4 x 6 mm pan screw (3) of the
choke cable holder (4) and tighten the 4 x 6 mm pan
screw to the specified torque again while pulling the
inner end of the choke cable slightly so that the choke
spring (5) of the choke arm is not compressed.
Check again that the choke lever is not loose by turning
it counterclockwise.
THROTTLE STOP SCREW
ADJUSTMENT
Remove the throttle stop screw (1) only if necessary for
carburetor repair or cleaning.
Install the throttle stop screw so that the throttle valve is
at the fully closed position and the throttle stop screw
end does not touch the throttle lever (2).
Tighten the throttle stop screw until the screw just
reaches the throttle lever. Tighten the throttle stop
screw an additional 2-1/4 turns when the screw starts to
push the throttle lever.
(1)
(3)
(2)
(4)
(5)
TORQUE: 2.3 N·m (0.23 kgf·m, 1.7 lbf·ft)
(1)
(2)
(3)
(4)
(1) (2)