© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
AII 13148-49239 (1302)
3 of 27
Setting the Control Unit
3.
Using a small flat-tip screwdriver, set the switches on
the (accessory) control unit to the locations shown.
NOTE:
•
The switches must be set before the control unit
is plugged in.
•
If the switch settings are not correct, the remote
engine starter will not operate correctly.
•
If setting the switches with the control unit
installed in the vehicle, touch the metal part of
the screwdriver to any metal part of the vehicle
to discharge any static electricity.
•
If you change the switch settings with the unit
connected, you must disconnect the unit, then
reconnect it before the new settings are
recognized.
921301AD
CONTROL
UNIT
SMALL FLAT-TIP
SCREWDRIVER
Discharge any
static electricity.
SET
SWITCHES
SWITCHES
SW:1 RR Junction unit --------------------> OFF
SW:2 Trunk or Tailgate ---------------------> ON
SW:3 Smart Entry----------------------------> OFF
SW:4 Horn or Buzzer Answerback-----> OFF
SW:5 Trunk Main SW------------------------> OFF
SW:6 Reserve ---------------------------------> OFF
4.
Using isopropyl alcohol on a shop towel, clean the
control unit where the protective tape will attach.
Remove the adhesive backing, and attach the
protective tape to the control unit over the switches.
772505AS
CONTROL
UNIT
SWITCHES
PROTECTIVE
TAPE
ADHESIVE
BACKING
Remove.
Clean with
isopropyl alcohol.
Removing the Vehicle Parts
5.
Remove the roof console.
•
Using a plastic trim tool, pry out and remove the
left and right lens (four retaining tabs each).
•
Open the sunglass holder and remove the four
screws.
•
Remove the roof console (unplug the vehicle
connectors).
Q0N2012AG
VEHICLE
CONNECTORS
ROOF
CONSOLE
4 SCREWS
4 RETAINING
TABS
LEFT
LENS
SUNGLASS
HOLDER
Open.
4 RETAINING
TABS
RIGHT
LENS
