2 of 27
AII 13148-49239 (1302)
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
Long wire tie
7
Urethane tapes
Template
Clip
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Diagonal cutters
Ratchet
8 mm, 10 mm, and 12 mm Sockets
Combination wrench
Isopropyl alcohol
Scissors
Small flat-tip screwdriver
Shop towel
Ruler
Tape measure
HDS (Honda Diagnostic System)
Needle nose pliers
Masking tape
Electrical tape
The following tool is available through the Honda Tool and
Equipment Program. On the iN click on: Service > Service
Bay > Tool and Equipment Program, the enter the number
under search. Or call 888-424-6857.
Trim Tool Set (T/N SOJATP2014)
Illustration of the Remote Control Engine Starter on
the Vehicle
Q0N2312AG
40A FUSE
CONTROL UNIT
ANTENNA
3 RELAYS
3A FUSE
ENGINE
STARTER
HARNESS
INSTALLATION
Customer Information:
The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
“do-it-yourselfers.”
NOTE: This antenna should only be installed if the
ambient air temperature 15°C (60°F) or above.
1.
Move the driver’s seat all the way back.
2.
Disconnect the negative cable from the battery.
