35
Slip the label card into the slot on one side next to the button
to be labeled then. Bow the label card upward slightly to push
it through to the opposite side in the slot. The label card should
now lay flat on the lighting sheet. Repeat the process for all other
label cards.
Finally, set the keypad cover back in place on the remote control
and latch it with the slider switch in the battery cabinet. Insert
the batteries again and close the battery compartment.
If no suitable label exists on the card provided, use the sheet of
unprinted labels. These labels can be printed with a standard
printer.
Templates can be downloaded under www.HomeMatic.com.
10 Error messages
10.1 Device LED
10.1.1 Low rechargeable battery
If the rechargeable batteries are too weak, the respective error
code (see section "Installing and changing rechargeable batter-
ies") is shown.
If the batteries are so weak that a reset is triggered several times
in a row without transmitting successfully, no transmission will
be made for following button presses and the LED will only be
illuminated in red for 0.5 seconds.
